ball catch door hardware – Firstly, discover the place the place the ball catch might be put in on high of the door. From the sting of the door, measure and mark 2 inches. This label centered between the again faces and entrance of the door. Measure the width and peak of the barrel within the clasp. Drill a gap (with barely deeper than the peak of the ball catch) centered on the situation mark. Drop the ball catch within the gap. Then, with the screws fasten the entrance panel to the highest of the door.
Shut the door and make a mark above the middle of the ball catch. Make one other mark on the aspect of the door body that marks the middle of the door body, as measured from the entrance of the door body to the door cease. Centered on the mark on the underside of the door body, drill a shallow gap. Set up the ball catch door hardware plate on the door body.
12 Photos Gallery of: Set Up A High Of The Ball Catch Door Hardware Lock
The indentation on the plate to suit into the shallow gap. Safe the plate to the bracket. Regulate the ball lock up or down as required by turning the ring is positioned instantly beneath the ball. Use a flat screwdriver to show the ring. Insert a nook of the screwdriver within the notch within the ring and push it to show the ring. The door ought to shut with out requiring a lot stress, and ought to be closed with out rattling round. Hold adjusting the clasp till the door closes passable. And the ball catch door hardware was prepared to make use of.