Great Plumbing Tips That Will Save You Money

Many people think that tackling their plumbing issues can be difficult. This is not necessarily true. Tackling a plumbing task, as with any task, can be easy if you have the right equipment and the right knowledge. The following article contains plumbing tips that will help you with any plumbing issue.

Act quickly if your pipes freeze! Shut off the water and open the faucet, enabling it to drain when it thaws. Starting with the faucet, and working your way to the iced-up area, aim a propane torch or hairdryer at the pipe – this will quickly defrost it. You could also wrap the pipe in a heating pad or aim a heat lamp at it, but this will take quite some time. A last resort is to wrap the pipe in rags and pour boiling water over it.

It is important to know how to properly anchor your pipes when it comes to plumbing. This is extremely important to know because not having your pipes well anchored could result in loud noises, leaks, or pressure problems. Call a professional if you are unsure how to take care of it yourself.

The areas of floor around your toilets are particularly susceptible to water damage; here’s how you can check them. Sit on the toilet and move from side to side, placing one foot on the ground. As you do, see if the floor lacks sturdiness or feels otherwise soft. You could save money if you notice these problems early.

Schedule your plumbing work simultaneously. By doing so, you can save up enough money to pay for the repairs. Most plumbers have an hourly rate and a flat rate for the trip: asking a plumber to fix multiple problems in one trip is cheaper than calling them more than once.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

In conclusion, tackling any plumbing issue does not have to be difficult. If you have the right tools and the right information to assist you, you can do any plumbing task that may arise. Simply use the tips that were provided in the article above and your plumbing issues will be a thing of the past.

sanny